 |
|
|
|
Problem/Possible cause | Solution |
The chip quality is not satisfactory |
|
1) The knives are dull 2) The anvil is worn 3)The knife has been worn too far (<28 mm) 4) The distance between the knife and the anvil is too large
| 1) Grind the knives 2) Turn/replace the anvil 3) Change the knives 4) Adjust the distance between the knives and the anvil
|
Poor throw of the chips |
|
1) Too little drive 2) Not enough revolutions on the machine 3) Driving belts too slack/worn | 1) Not enough effect on the PTO axle or engine 2) Increase speed to maximum revolutions 3) Adjust the belts/change the belts |
Engine problems |
|
MOBILE-models | See the user´s manual for B&S engines |
